No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Guide for Interworking Between HUAWEI CloudFabric Solution and Redhat OpenStack

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Interconnecting the Agile Controller-DCN with the CE1800V

Interconnecting the Agile Controller-DCN with the CE1800V

Discovering Devices

  1. Choose Network > Physical Resource > Device Management from the main menu.
  2. Select Discover Registered Device from the Device Discovery drop-down list box.

  3. Download the template to the local PC.

  4. Edit and save the template, as shown in the following figure.

  5. Upload the template.

  6. Verify that the devices are discovered successfully.

Configuring the OpenFlow and OVSDB Protocols

  1. Choose System > Southbound Protocol > OpenFlow > OpenFlow Configuration, enable the OpenFlow port, and click Apply.

  2. Choose System > Southbound Protocol > OVSDB > OVSDB Configuration, enable the OVSDB port, and click Apply.

Adding Routes between the Agile Controller-DCN and CE1800V

  1. On the Agile Controller-DCN, add a route to the CE1800V.

  2. On the CE1800V, add a route to the Agile Controller-DCN.

  3. Configure the external network interface for the compute nodes to connect to the switch.

    [~TOR2-10GE1/0/14] display this
    #
    interface 10GE1/0/14
    port default vlan 52
    #
    return
    [~TOR2-10GE1/0/14]int 10ge1/0/16
    [~TOR2-10GE1/0/16]dis th
    #
    interface 10GE1/0/16
    port default vlan 52
    #
    Return

  4. Modify the qemu.conf file.

  5. Modify the huawei_driver_config.ini file.

  6. Verify that the CE1800V status is normal on the Agile Controller-DCN.

Adding Devices to the Fabric Network

  1. Choose Network > Network Management > Fabric to open the created Fabric network.

  2. Click Add to add compute nodes.

Download
Updated: 2019-03-25

Document ID: EDOC1100072313

Views: 3284

Downloads: 22

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next