No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Huawei SAP HANA Appliance HA and DR Scheme Configuration Guide 02

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration on the Yast2 (for SUSE)

Configuration on the Yast2 (for SUSE)


The following operations use the system replication port bond_sr (physical ports eth3 and eth4 of different NICs) as an example.

  1. Log in to the DR server node.
  2. Run yast2, click Network Devices, and then click Network Settings.

  3. Select the first 10GE network port and click Edit.

  4. Select No Link and IP Setup (Bonding Slaves) and click Next.

  5. Repeat the preceding steps to configure the second 10GE port.
  6. Click Add.

  7. Select Bond, enter the name bond_sr, and click Next.

  8. Select Statically assigned IP Address, and enter the planned IP address and subnet mask.

  9. Click the Bond Slaves tab, select the two network ports (one from each NIC) to be bonded. In Bond Driver Options, select mode=2 (or mode=balance-xor), and click Next.


    The configured bonding mode must be consistent with the bonding mode of the switch port on the network.

  10. Repeat the preceding steps to configure other bond network ports. Then, click OK to save the configuration.

  11. Log in to server node 2 and set IP addresses in the same way.
Updated: 2019-03-30

Document ID: EDOC1100073265

Views: 1273

Downloads: 8

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next