No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eLog V200R007C10 Installation Guide

Describes the installation process of product software. Includes plans, environmental requirements, and procedures for installation, as well as commissioning procedures.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an IP address for iBMC Port

Configuring an IP address for iBMC Port

After an IP address is assigned to the iBMC port of the server, you can use the web UI to manage the remote management server through this IP address.

Method 1: Setting an IP Address by Connecting a Laptop to the iBMC Port

A PC or laptop where the Internet Explorer is installed is ready, and a network cable is ready.

  1. Check the location of the iBMC port of the server and connect a PC to the port using a cable.
  2. Change the IP address and subnet mask of the PC. The PC resides on the same subnet as the iMana port.

    NOTE:

    The default IP address and subnet mask of the iBMC port is 192.168.2.100 and 255.255.255.0 respectively.

  3. Enter the IP address of the iBMC port in the address bar of the Internet Explorer on the PC and press Enter.

    The "There is a problem with this website's security certificate." Message is displayed.

  4. Click Continue to this website.

    The user login page is displayed.

    Figure 3-9 Login UI of the iBMC port

  5. Enter the user name and password, select This iBMC, and click Log In.

    NOTE:
    • The default user name is Administrator.
    • The default password is Admin@9000.

  6. Choose Config > Network Settings.
  7. In IPv4 area of 3. Select IP Version and Set IP select Manually Set an IP Address and select IP Address, Mask, and Default Gateway. Click Save.
  8. Disconnect the PC from the iBMC port of the server and connect the iBMC port to the network.
  9. Change the IP address of the PC to connect the PC to the same network.
  10. Enter the new IP address of the iBMC port in the address bar of the Internet Explorer to access the web UI of the iBMC port.

Method 2: Setting an IP Address in BIOS by Connecting the Mouse and Keyboard to the Server

  1. Connect the monitor and keyboard to a server and power on the server.
  2. Start the server. If the following information is displayed, repeatedly press Delete.

  3. Enter the password to access the configuration page.

    The initial password is Admin@9000 .

  4. Press arrow keys to access the Advanced tab and select IPMI iBMC Configuration. Then click Enter.

  5. Press arrow keys to select iBMC Configuration and click Enter.

  6. Press arrow keys to move the cursor to IP Address and press F5 to change the IP address of the iBMC port.

    Use the same method to change the subnet mask and default gateway.

  7. Press F10 to save the configuration and exit.
  8. Repeat the preceding operations to configure IP addresses for all iBMC ports.
Translation
Download
Updated: 2019-04-01

Document ID: EDOC1100073937

Views: 8157

Downloads: 16

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next