Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Changing Pre-installation Parameter Values (eLog Pre-installed)
In a pre-installation scenario of a centralized or distributed analyzer or a distributed collector (with a disk), the eLog software is installed. Change pre-installation parameters as described in this section.
- Changing the IP Address of the Analyzer or Collector
You need to change the IP address during the pre-installation based on the actual networking and IP address planning. - Changing the Time and Time Zone of the Operating System
The system time and time zone of a shipped server may differ from the actual values. For normal use, please adjust the system time and time zone of the server. This section describes how to change the system time and time zone. - Configuring the NTP Component
This section describes how to install and configure the NTP server and NTP client on the eLog analyzer and collector. For details on NTP configurations on the log source, refer to the related manuals. - (Optional) Changing the User Password of the Operating System
You are advised to change the initial password of the Operating System. Periodically changing the user password of Linux can improve user information security. - (Optional) Changing the Database Password of the Analyzer
This section describes how to change the database password of the eLog analyzer.
Previous
