No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eLog V200R007C10 Installation Guide

Describes the installation process of product software. Includes plans, environmental requirements, and procedures for installation, as well as commissioning procedures.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Handling the Installation Failure

Handling the Installation Failure

This section describes how to handle the installation failure caused by power failure, restart, and system crash of the eLog analyzer or the misoperations of the maintenance personnel.

Procedure

  1. If the system prompts you that the omm already exists, run the userdel omm command to delete the user, and perform the installation procedure again. If the prompt is not displayed, go to step 2.

    Before performing this step, ensure that the eLog has been stopped. Otherwise, the eLog cannot be deleted after the omm account is deleted, resulting in an uninstallation failure. You can run checkrunning.sh to check whether every eLog service has been stopped. For how to use check_running.sh, see Verifying the Installation.

  2. Check whether the power failure occurs on the eLog analyzer. If the power indicator of the server is off, the power failure occurs on the server. Power on the server again.
  3. Use the root account to log in to the operating system.
  4. Uninstall the eLog.

    1. Right-click the desktop to open the terminal.
    2. Run the cdsoftware installation directory/engineering/tools to open the directory that houses the startup file.
    3. Run the ./uninstall.sh command to uninstall the eLog.
    • If the uninstallation succeeds, re-install the eLog.
    • If the uninstallation fails, proceed with the following steps.

  5. Delete the installation directory, for example, /opt/huawei/LogCenter.
  6. Re-install the eLog.
Translation
Download
Updated: 2019-04-01

Document ID: EDOC1100073937

Views: 7524

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next