No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


eLog V200R007C10 Installation Guide

Describes the installation process of product software. Includes plans, environmental requirements, and procedures for installation, as well as commissioning procedures.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Starting the Analyzer or Collector

Starting the Analyzer or Collector

After completing the initial configuration, you need to start the eLog analyzer and collector.


In centralized mode, you just need to start the analyzer. In distributed mode, you need to start both the analyzer and collector.


  1. Use the omm account to log in to the operating system.
  2. Right-click the desktop to open the terminal.
  3. Run the cd software-installation-path/engineering/tools command to access the directory.

    The default directory is /opt/huawei/LogCenter/engineering/tools.

  4. Run the ./ command to start the analyzer or collector.
  5. The analyzer or collector starts properly if the following information is displayed.

    All service start up success.

    Ensure that the eLog analyzer has been started before starting the eLog collector.

Updated: 2019-04-01

Document ID: EDOC1100073937

Views: 8956

Downloads: 16

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next