No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionInsight HD 6.5.0 Administrator Guide 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Alarm Masking Status

Configuring the Alarm Masking Status

Scenarios

If you do not want FusionInsight Manager to report specified alarms in the following scenarios, you can manually mask the alarms.

  • Some unimportant alarms and minor alarms need to be masked.
  • When a third-party product is integrated with FusionInsight, some alarms of the product are duplicated with the alarms of FusionInsight and need to be masked.
  • When the deployment environment is special, certain alarms may be falsely reported and need to be masked.

After an alarm is masked, new alarms with the same ID as the alarm are neither displayed on the Alarm page nor counted. The reported alarms are still displayed.

Procedure

  1. Log in to FusionInsight Manager.
  2. Choose O&M > Alarm > Masking Setting.
  3. In the Masking Setting area, select the specified service or module.
  4. Select an alarm from the alarm list.

    Figure 7-4 Masking an alarm
    The information about the alarm is displayed, including the alarm name, ID, severity, masking status, and operations can be performed on the alarm.
    • The masking status includes Display and Mask.
    • Operations include Mask and Help.
    NOTE:

    You can filter specified alarms based on the masking status and alarm severity.

  5. Set the masking status for an alarm:

    • Click Mask. In the displayed dialog box, click OK to change the alarm masking status to Mask.
    • Click Cancel Masking. In the displayed dialog box, click OK to change the masking status of the alarm to Display.

Download
Updated: 2019-05-17

Document ID: EDOC1100074522

Views: 6216

Downloads: 12

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next