No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Dynamic 1588v2 (Using Switches as BCs)

Configuring Dynamic 1588v2 (Using Switches as BCs)

Context

You can configure 1588v2 on BCs and use the BMC algorithm to determine the master-slave hierarchy between the GMC and devices on a 1588v2 clock synchronization network.

BC Deployment

In Figure 6-18, NodeBs need to synchronize the time with an external clock source. All the devices on the network support 1588v2. Each device receives clock signals from an upstream device and sends clock signals to a downstream device. In this manner, NodeBs can synchronize the time with the external clock source. The device connected to the external clock source is configured as a BC to synchronize the time with the external clock source and send clock information to other devices on the network. Other backbone nodes on the network are also deployed as BCs to synchronize the time with the external clock source and send clock information to downstream devices.

Figure 6-18 Configuring 1588v2 on BCs

Pre-configuration Tasks

Set link layer protocol parameters for interfaces to ensure that the link layer protocol status of the interfaces is Up.

Configuration Procedure

The following configuration tasks must be performed in sequence.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074722

Views: 11089

Downloads: 10

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next