No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Device to Output Traps to a Terminal

Configuring the Device to Output Traps to a Terminal

Context

After traps are output to a user terminal, you can view traps on the user terminal (host from which you log in to the device through Telnet) to monitor device running.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run info-center monitor channel { channel-number | channel-name }

    A channel through which traps are output to a user terminal is specified.

    By default, the device uses channel 1 to output traps to a user terminal.

  3. Run info-center source { module-name | default } channel { channel-number | channel-name } trap { state { off | on } | level severity } *

    A rule for outputting traps to a channel is set.

    By default, channel 1 is enabled to output traps and the lowest severity is debugging.

  4. Run commit

    The configuration is committed.

  5. Run quit

    Return to the user view.

  6. Run terminal monitor

    Display of logs, traps, and debugging message output is enabled on the user terminal.

    By default, console display is enabled and terminal display is disabled.

  7. Run terminal trapping

    Traps display is enabled on the user terminal.

    By default, trap display is enabled on the user terminal.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074722

Views: 10995

Downloads: 10

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next