No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the Running Status of NTP

Monitoring the Running Status of NTP

Context

To monitor the NTP running status after configurations of NTP are complete, run the following commands in any view.

Procedure

  • Run display ntp statistics packet [ ipv6 | [ ipv6 ] interface { interface-type interface-number | all } | peer [ [ ip-address [ vpn-instance vpn-instance-name ] ] | ipv6 [ ipv6-address [ vpn-instance vpn-instance-name ] ] | domain [ domain-name [ vpn-instance vpn-instance-name ] ] ] ]

    The statistics on NTP packets or symmetric peers are checked.

  • Run display ntp slot-status

    The status of the clock system of a board on a device is checked.

  • Run display ntp status

    Check the status information of NTP.

  • Run display ntp sessions [ verbose ]

    All session information maintained by the local NTP service is checked.

  • Run display ntp trace

    The path from the local device to the reference clock source is checked.

  • Run display ntp event clock-unsync

    The reasons of the last 10 clock synchronization failures are checked.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074722

Views: 10956

Downloads: 10

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next