No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Outputting Debugging Messages to the Console

Example for Outputting Debugging Messages to the Console

Networking Requirements

As shown in Figure 3-10, the PC connects to SwitchA through a console interface. It is required that debugging messages of the ARP module be displayed on the PC.

Figure 3-10 Networking diagram for outputting debugging messages to the console

Configuration Roadmap

The configuration roadmap is as follows:

  1. Enable the information center.

  2. Configure a channel and a rule for outputting debugging messages to the console so that the console can receive debugging messages generated by SwitchA.

  3. Enable terminal display so that users can use the terminal to view debugging messages generated by SwitchA.

Procedure

  1. Enable the information center.

    <HUAWEI> system-view
    [~HUAWEI] sysname SwitchA
    [*HUAWEI] commit
    [~SwitchA] info-center enable
    [*SwitchA] commit

  2. Configure a channel and a rule for outputting debugging messages to the console.

    # By default, the system outputs debugging messages to the console through channel 0. You can configure the rule for outputting debugging messages to the console.

    [~SwitchA] info-center source arp channel console debug level debugging state on
    [*SwitchA] commit
    [~SwitchA] quit

  3. Enable terminal display.

    <SwitchA> terminal monitor
    Info: Current terminal monitor is on.
    <SwitchA> terminal debugging
    Info: Current terminal debugging is on.

  4. Debug the ARP module.

    <SwitchA> debugging arp packet

  5. Verify the configuration.

    # View the channel used by the Console to output debugging messages.

    <SwitchA> display info-center channel 0
    channel number:0, channel name:console
    ModuID   Name          Enable LogLevel      Enable TrapLevel     Enable DebugLevel
    ffffffff default       Y      warning       Y      debugging     Y      debugging
    00000859 ARP           Y      warning       Y      debugging     Y      debugging
    

Configuration Files

  • Configuration file of SwitchA
    #
    sysname SwitchA
    #
    info-center source arp channel 0
    #
    return
    
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074722

Views: 11084

Downloads: 10

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next