No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Clock Link Mode for a Stack Member Port in a Stack

Configuring the Clock Link Mode for a Stack Member Port in a Stack

Prerequisites

A stack has been established.

Context

To ensure clock or time synchronization between member switches in a stack, you must set the clock link mode of stack member ports to the interlink mode.

NOTE:

In a stack, after the clock link mode of stack member ports is set to the interlink mode, you still need to finish the subsequent synchronous Ethernet configuration, which is the same as the synchronous Ethernet configuration of a standalone switch.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view corresponding to a stack member port is displayed.

  3. Run clock link-mode interlink

    The clock link mode is set to the interlink mode on the stack member port.

    NOTE:
    • The clock link mode of stack member ports on each stack member switch must be set to the interlink mode.
    • Each chassis can have no more than two stack member ports configured as interlink ports. Clock source or other clock configuration commands cannot be configured on interlink ports.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074722

Views: 14126

Downloads: 18

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next