No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Basic NTP Function Configuration

Verifying the Basic NTP Function Configuration

Prerequisites

All configurations of basic NTP functions are completed.

Procedure

  • Run the display ntp status command to check the NTP service status.
  • Run the display ntp sessions [ verbose ] command to check the NTP session status.
  • Run the display ntp trace command to check the path from the local device to the reference clock source.
  • Run the display ntp statistics packet [ ipv6 | [ ipv6 ] interface { interface-type interface-number | all } | peer [ [ ip-address [ vpn-instance vpn-instance-name ] ] | ipv6 [ ipv6-address [ vpn-instance vpn-instance-name ] ] | domain [ domain-name [ vpn-instance vpn-instance-name ] ] ] ] command to check the statistical information about NTP packets or symmetric peers.
  • Run the display ntp slot-status command to check the state of the clock system of the board on the device.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074722

Views: 11338

Downloads: 10

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next