No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Static Member Port

(Optional) Configuring a Static Member Port

Context

A member port on a Layer 2 device connects to receiver hosts which are multicast group members. Group member ports can be configured manually or learned dynamically by multicast protocols. When MLD snooping is enabled in a VLAN, all interfaces in this VLAN learn forwarding entries from multicast packets. When an interface receives MLD Report messages, the Layer 2 device marks this interface as a dynamic member port. Dynamic member ports have an aging time.

If user hosts connected to an interface need to receive the multicast packets destined for a specific group or sent from a source to a group, you can add the interface to the group or source-group manually. This interface then becomes a static member port. The static member port never ages.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

  3. (Optional) Run mld snooping learning disable vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }

    Dynamic learning of member ports is disabled.

    By default, dynamic learning of member ports is enabled. After dynamic learning of member ports is disabled, to forward multicast data, interfaces must be statically added to a multicast group.

  4. Run mld snooping static-group [ source-address source-ip-address ] group-address group-ip-address vlan { vlan-id1 [ to vlan-id2 ] } &<1-10>

    An interface is manually added to a multicast group. The interface becomes the static router port.

    Or run mld snooping static-group [ source-address source-ip-address ] group-address group-ip-address1 to group-ip-address2 vlan vlan-id

    The interface is added to multiple multicast groups.

    By default, a static router port is not configured.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074724

Views: 45857

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next