No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the IGMP Snooping Version

Configuring the IGMP Snooping Version

Context

Internet Group Management Protocol (IGMP) manages multicast group members and runs on the network segments where Layer 3 multicast devices connect to user hosts. IGMP has three protocol versions V1, V2, and V3. You can specify the IGMP snooping version on a Layer 2 device to enable the device to process IGMP messages of the specified version. Generally, the version on the Layer 2 device should be the same as that on the Layer 3 multicast device. If IGMP is disabled on the Layer 3 multicast device, configure the same IGMP version as member hosts or a higher IGMP version.

Devices in the same VLAN must run the same IGMP version. When hosts that run different IGMP versions exist in a VLAN, set an appropriate IGMP snooping version to enable the switch to process IGMP messages of different versions.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    The VLAN view is displayed.

  3. Run igmp snooping version version

    The version of IGMP messages that the switch can process is set.

    By default, the switch can process IGMPv1 and IGMPv2 messages but cannot process IGMPv3 messages.

    NOTE:

    When MAC address-based forwarding is enabled in the VLAN, IGMPv3 cannot be configured.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074724

Views: 39013

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next