No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the MLD Snooping Running Status

Monitoring the MLD Snooping Running Status

Context

During routine maintenance, you can run the following commands in any view to monitor the MLD snooping running status.

Procedure

  • Run the display mld snooping [ vlan [ vlan-id ] ] configuration command to check the MLD snooping running parameters and configuration in a VLAN.
  • Run the display mld snooping port-info [ vlan vlan-id [ group-address group-address ] ] [ slot slot-id ] [ verbose ] command to check information about member ports.
  • Run the display mld snooping router-port vlan vlan-id command to check information about router ports.
  • Run the display mld snooping querier vlan [ vlan-id ] command to check information about the MLD snooping querier.
  • Run the display mld snooping statistics vlan [ vlan-id ] command to check MLD snooping statistics.
  • Run the display multicast layer-2 ipv6 fib [ vlan vlan-id [ [ source source-address ] group group-address ] ] command to check the Layer 2 multicast forwarding table in a VLAN.
  • Run the display mld snooping group interface interface-type interface-number vlan vlan-id [ [ source-address source-address ] group-address group-address ] command to check information about multicast groups that are learned dynamically.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074724

Views: 44674

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next