No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
User Hosts in the User VLAN Fail to Receive Multicast Data

User Hosts in the User VLAN Fail to Receive Multicast Data

Fault Description

After VLAN-based multicast VLAN replication is configured, user hosts in the user VLAN cannot receive multicast data.


  • Check whether multicast VLAN replication is correctly configured.

    Run the display multicast vlan mvlan [ vlan-id ] command to check whether the user VLAN is bound to a correct multicast VLAN.

    • If the user VLAN is not bound to a correct multicast VLAN, run the multicast vlan user-vlan command to bind VLANs correctly.
    • If the user VLAN is bound to a correct multicast VLAN, check whether other Layer 2 multicast configurations conflict.
      The following information shows that user VLANs 100 and 200 are bound to multicast VLAN 10 correctly.
      <HUAWEI> display multicast vlan mvlan 5 
       Multicast-vlan         : 10                                                                                                         
       User-vlan Number       : 2                                                                                                         
       IGMP snooping state    : Enable                                                                                                    
       User-vlan              Snooping-state                                                                                              
       100                    IGMP Enable                                                                                                 
       200                    IGMP Enable                                                                                                
Updated: 2019-04-20

Document ID: EDOC1100074724

Views: 45917

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next