No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the MSDP Running Status

Monitoring the MSDP Running Status

Context

During the routine maintenance, you can run the following commands in any view to learn the MSDP running status.

Procedure

  • Run the display msdp [ vpn-instance vpn-instance-name | all-instance ] brief [ state { connect | down | listen | shutdown | up } ] command to check brief information about MSDP peers.
  • Run the display msdp [ vpn-instance vpn-instance-name | all-instance ] peer-status [ peer-address ] command to check the detailed information about MSDP peers.
  • Run the display msdp [ vpn-instance vpn-instance-name | all-instance ] sa-cache [ group-address | source-address | as-number ] * command to check (S, G) information in the SA cache.
  • Run the display msdp [ vpn-instance vpn-instance-name | all-instance ] sa-count [ as-number ] command to check the number of (S, G) entries in the SA cache.
  • Run the display msdp [ vpn-instance vpn-instance-name | all-instance ] control-message counters [ peer peer-address | message-type { source-active | sa-request | sa-response | keepalive | notification | traceroute-request | traceroute-reply | data-packets | unknown-type } ] * command to check the statistics on the received, sent, and discarded MSDP packets.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074724

Views: 45452

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next