No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
MENU
Support Documentation

Configuration Guide - IP Multicast

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Multicast Deployment on an IPv6 Network

Multicast Deployment on an IPv6 Network

This section describes typical multicast service scenarios on an IPv6 network and applications of multicast protocols. Configure multicast services based on the actual situations and service requirements on your network. This section provides only deployment of basic multicast services.

Before deploying IPv6 multicast services on a network, ensure that IPv6 unicast routes on the network are reachable.

Figure 1-10 Basic IPv6 multicast service deployment

Table 1-13 Multicast protocols used for multicast on an IPv6 Network

Protocol

Application Position

Purpose

IPv6 PIM (mandatory)

IPv6 PIM must be configured on all interfaces of Layer 3 multicast devices, including all interfaces of RouterA, RouterB, RouterC and RouterD.

For the configuration procedure, see IPv6 PIM Configuration.

IPv6 PIM sends multicast data from multicast source to RouterC and RouterD connected to multicast receivers.

MLD (mandatory)

MLD must be configured on user-side interfaces of Layer 3 multicast devices RouterC and RouterD.

For the configuration procedure, see MLD Configuration.

MLD allows receiver hosts to join or leave multicast groups, and allows RouterC and RouterD to maintain and manage multicast memberships.
Translation
简体中文
Download
Updated: 2019-04-20

Document ID: EDOC1100074724

Views: 45878

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next
Enterprise APP

Copyright © 2019 Huawei Technologies Co., Ltd. All rights reserved.