No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IGMP

Configuring IGMP

Context

To forward multicast data based on local Layer 2 multicast entries after VXLAN decapsulation, a VXLAN gateway must be capable of forwarding both Layer 2 and Layer 3 multicast traffic at the same time. To achieve this capability, the VXLAN gateway must have IGMP and related parameters configured on its VBDIF interface.

NOTE:

After IGMP is configured on a VBDIF interface, IGMP snooping is automatically enabled in the corresponding BD and inherits the parameter settings on the VBDIF interface. However, related configurations are not displayed in the BD view. To check them, you can only run the display igmp snooping bridge-domain bd-id command. If you manually modify IGMP snooping configurations in the BD view, the modification does not take effect. What takes effect is still the configurations inherited from the VBDIF interface.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface vbdif bd-id

    The VBDIF interface view is displayed.

  3. Run pim sm

    PIM-SM is enabled.

  4. Run igmp enable

    IGMP is enabled.

    By default, IGMP is disabled on interfaces.

  5. Run commit

    The configuration is committed.

Follow-up Procedure

Configure IGMP-related functions as needed. Perform interface configurations in the VBDIF interface view. For details, see "IGMP Configuration". The following configuration tasks are not supported:

  • Configure an IGMP user to statically join a multicast group.

  • Configure IGMP host tracking.

  • Configure IGMP on-demand.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074724

Views: 44326

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next