No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Inter-AS Multicast Using MBGP and MSDP

Inter-AS Multicast Using MBGP and MSDP

Both Multiprotocol Border Gateway Protocol (MBGP) connections and MSDP connections are TCP connections. You can set up an MBGP peer relationship between two MSDP peers to ensure that SA messages can pass the RPF check.

Figure 6-7 Inter-AS multicast using MBGP and MSDP

As shown in Figure 6-7, the RPs in different PIM-SM domains are not directly connected to each other and the RPs and ASBRs are deployed on different routers. After you set up MSDP peer relationships between the RPs, you can also set up MBGP peer relationships between them to ensure that SA messages can pass the RPF check.

  • IBGP: set up IBGP peer relationships for RPs in the same AS, such as RP1 and RP2, and RP3 and RP4.

  • EBGP: set up EBGP peer relationships for RPs in different ASs, such as RP1 and RP3, and RP2 and RP4.

The MBGP peer relationship and MSDP peer relationship must be set up on the same interface. MBGP and MSDP are frequently used together. For details about MBGP, see "BGP" in the CloudEngine 12800 and 12800E Series Switches Configuration Guide- IP Routing.

Updated: 2019-04-20

Document ID: EDOC1100074724

Views: 45831

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next