No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IGMP Fast Leave

Configuring IGMP Fast Leave

Context

In some scenarios, a querier interface connects to only one receiver host. If the host frequently switches between multiple multicast groups, you can configure the fast leave function on the interface so that the interface can quickly respond to Leave messages sent from the host.

After the fast leave function is configured, the querier does not send a Group-Specific Query message after receiving a Leave message from the host. Instead, the querier directly notifies the upstream multicast device that the host has left the multicast group. The fast leave function reduces delay in response to Leave messages and saves network bandwidth.

IGMP fast leave applies only to IGMPv2 and IGMPv3.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

    The mode switching function takes effect when the interface only has attribute configurations (for example, shutdown and description configurations). Alternatively, if configuration information supported by both Layer 2 and Layer 3 interfaces exists (for example, mode lacp and lacp system-id configurations), no configuration that is not supported after the working mode of the interface is switched can exist. If unsupported configurations exist on the interface, delete the configurations first and then run the undo portswitch command.

    NOTE:

    If many Ethernet interfaces need to be switched to Layer 3 mode, run the undo portswitch batch interface-type { interface-number1 [ to interface-number2 ] } &<1-10> command in the system view to switch these interfaces to Layer 3 mode in batches.

  4. For a Layer 3 sub-interface, run the following commands to configure termination of single-tagged packets on it.
    1. Run quit

      Return to the system view.

    2. Run interface interface-type interface-number.subinterface-number

      The Layer 3 sub-interface view is displayed.

      The subinterface-number parameter must specify a Layer 3 sub-interface number on an Ethernet interface that has been switched to the Layer 3 mode.

    3. Run dot1q termination vid vid

      Termination of Dot1q packets is configured on the Layer 3 sub-interface.

      By default, the termination of Dot1q packets is not configured on a Layer 3 sub-interface.

  5. Run igmp prompt-leave [ group-policy { acl-number | acl-name acl-name } ]

    Fast leave is configured on the interface.

    By default, the switch sends a Group-Specific Query message after receiving a Leave message.

  6. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074724

Views: 40909

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next