No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the MLD Version

Configuring the MLD Version

Context

MLD maintains group memberships between Layer 3 multicast devices and user hosts. Two versions are available: v1 and v2. After an MLD version is specified on a Layer 2 switch, the switch can process MLD messages of the specified version. Generally, a Layer 2 device and its upstream Layer 3 multicast device must run the same MLD version. If MLD is disabled on the Layer 3 multicast device, the MLD version on the Layer 2 device must be the same as or higher than that on user hosts.

User hosts in the same VLAN must run the same MLD version. If user hosts in a VLAN support different MLD versions, set the MLD version to MLDv2 on the Layer 2 device so that the device can process MLD messages from all user hosts.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    The VLAN view is displayed.

  3. Run mld snooping version version

    The MLD version is specified.

    By default, the switch can process MLDv1 and MLDv2 messages.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074724

Views: 39497

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next