No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Multicast Between PIM-SM Domains Within an AS Using MSDP

Multicast Between PIM-SM Domains Within an AS Using MSDP

When the multicast source and the receiver are located in different PIM-SM domains of the same AS, you can configure MSDP peers on the RPs to implement inter-domain multicast.

Figure 6-6 PIM-SM inter-domain multicast in an AS

As shown in Figure 6-6, the MSDP peer relationship is set up between RPs of two PIM-SM domains. In this manner, information about the multicast source is shared between the two domains.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074724

Views: 44260

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next