No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
IPv6 Multicast Protocols

IPv6 Multicast Protocols

Table 1-9 describes multicast protocols on an IPv6 network.

Table 1-9 IPv6 multicast protocols




Multicast Listener Discovery (MLD)

MLD manages IPv6 multicast group members and runs on the end of a multicast network (network segments where Layer 3 multicast devices connect to user hosts). Hosts use the MLD protocol to join or leave multicast groups. Layer 3 multicast devices use the MLD protocol to manage and maintain group memberships. MLD can interact with upper-layer multicast routing protocols.

MLD has two versions: MLDv1 and MLDv2.

MLDv2 can be independently used in the source-specific multicast (SSM) model, whereas MLDv1 must use SSM mapping.

MLD works on an IPv6 network in the same way IGMP works on an IPv4 network. MLDv1 is similar to IGMPv2, and MLDv2 is similar to IGMPv3.

Protocol Independent Multicast (PIM) for IPv6

IPv6 PIM runs on an IPv6 network and sends multicast data to multicast devices connected to multicast group members interested in the data flows.

The CE12800 and CE12800E series switches support IPv6 Bidir-PIM and IPv6 PIM-SM. IPv6 Bidir-PIM applies to networks with many multicast sources. IPv6 PIM-SM applies to large-scale networks with sparsely distributed group members.

IPv6 PIM-SM differentiates between the ASM and SSM models based on multicast addresses in multicast data and protocol packets.
  • If multicast addresses of packets are in the range of SSM group addresses, IPv6 PIM-SM uses the SSM model to provide multicast services. The IPv6 PIM-SSM model is efficient and simplifies the multicast address allocation process. It is applicable when a group has only one specific source.
  • If multicast addresses of packets are in the range of ASM group addresses, IPv6 PIM-SM uses the ASM model to provide multicast services.
Updated: 2019-04-20

Document ID: EDOC1100074724

Views: 39056

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next