No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Typical Multicast VPN Application

Typical Multicast VPN Application

Multicast VPN isolates multicast services of different VPN instances in a single AS.

Figure 7-16 Intra-AS multicast VPN

As shown in Figure 7-16, BGP/MPLS IP VPN runs in a single AS. PE1, PE2, and PE3 are configured with two VPN instances: VPNA and VPNB, and the same Share-Group address is set for the same VPN instance on the PEs. The VPN instances with the same Share-Group address join the same MD. After the Share-MDT is established, the protocol packets and data packets on the VPNs can be transmitted through their corresponding MTs.

To implement VPN multicast services in an AS, perform the following configurations:

  • Configure reachable routes and run MPLS on the public network. Run routing protocols between PEs and CEs, and establish BGP peer relationships between PEs to transmit VPN route information.
  • Enable IP multicast routing for the public network instance and VPN instances on PEs. Enable PIM-SM on all interfaces connecting to the public network and to VPN sites. If PIM-SM is enabled, select appropriate C-BSRs, C-RPs, or a static RP on the public network.
  • Enable IGMP on interfaces of PEs or CEs connected to sites where receivers exist.
  • Enable IP multicast routing on devices at each site. Enable PIM-SM on all interfaces of the devices. If PIM-SM is enabled, select appropriate C-BSRs, C-RPs, or a static RP at the site.
  • Configure different Share-Group addresses and Switch-Group-Pool ranges for VPNA and VPNB.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074724

Views: 44261

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next