No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
STACKMNG_1.3.6.1.4.1.2011.5.25.183.1.22.47 hwStackMemberPortProtocolAlarm

STACKMNG_1.3.6.1.4.1.2011.5.25.183.1.22.47 hwStackMemberPortProtocolAlarm

Description

The physical status of the stack member port is up, but the protocol status is down. (hwStackLocalIfName=[hwStackLocalIfName])

The physical status of the stack member port is Up, but its protocol status is Down.

Attribute

Attribute

Description

Alarm or Event

Alarm

Trap Severity

Warning

Mnemonic Code

hwStackMemberPortProtocolAlarm

Trap OID

1.3.6.1.4.1.2011.5.25.183.1.22.47

Alarm ID

0x09a22023

Alarm Type

communicationsAlarm

Raise or Clear

Raise

Match trap

STACKMNG_1.3.6.1.4.1.2011.5.25.183.1.22.48 hwStackMemberPortProtocolAlarmResume

Parameters

Name Meaning

hwStackLocalIfName

Indicates the name of the stack member port.

VB Parameters

VB OID

VB Name

VB Index

1.3.6.1.4.1.2011.5.25.183.1.32.1

hwStackLocalIfName

N/A

Impact on the System

The link connecting to the stack member port is unavailable.

Possible Causes

The connection of the stack member port is incorrect or stack protocol packets are received or sent incorrectly.

Procedure

  1. Check whether the connection of the stack member port is correct. If not, correct it.
  2. Run the display interface interface-type interface-number command to check whether error packet statistics exist on the port. If so, check whether the optical modules of the two ends are properly inserted or have any fault.
  3. Run the display stack statistics command in the diagnostic view more than once to check whether the statistics about stack protocol packets sent or received are correct. If not, check the stack configuration or connections.
  4. Collect the trap, log, and configuration information, and then contact technical support personnel.
Translation
Download
Updated: 2019-04-02

Document ID: EDOC1100074754

Views: 22423

Downloads: 30

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next