No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Alarm Handling

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
STACKMNG_1. hwStackMemberLeave

STACKMNG_1. hwStackMemberLeave


The stack member device left. (hwStackIdIndex=[hwStackIdIndex], hwStackId=[hwStackId], hwStackMacAddress=[hwStackMacAddress])

The stack member device left.




Alarm or Event


Trap Severity


Mnemonic Code


Trap OID

Alarm ID

This is an event trap and does not involve alarm ID.

Alarm Type

This is an event trap and does not involve alarm type.

Raise or Clear

This is an event trap and does not involve alarm generation or clearance.

Match trap

This is an event trap and does not involve the matching trap.


Parameter Meaning
hwStackIdIndex ID index of the stack member.


ID of the stack member.

hwStackMacAddress MAC address of the device.



VB Name

VB Index



Impact on the System

The stack is split or the member leaves the stack system.

Possible Causes

The member device leaves the stack system.


  1. Check whether the member device is deleted manually from the stack system.

    • If so, no action is required.

    • If no, go to step 2.

  2. Run the display interface brief command to check whether the stack interface is Down.

    • If so, rectify the fault.
    • If no, go to step 3.

  3. Run the display stack configuration command to check whether the stack configuration complies with the requirement.

    • If so, go to step 4.
    • If no, modify the stack configuration.

  4. Collect trap messages, log messages, and configurations, and then contact technical support personnel.
Updated: 2019-04-02

Document ID: EDOC1100074754

Views: 25217

Downloads: 31

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next