No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IPv6 BFD for IS-IS Processes

Configuring IPv6 BFD for IS-IS Processes

By configuring IPv6 BFD for an IS-IS process, you can set parameters for dynamic BFD sessions and enable dynamic IPv6 BFD for IS-IS on all IS-IS interfaces.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run isis process-id

    The IS-IS view is displayed.

  3. Run ipv6 bfd all-interfaces enable

    IPv6 BFD is enabled in the IS-IS process to establish BFD sessions.

    When global IPv6 BFD is enabled in the IS-IS process and the neighbor IPv6 status is Up, IS-IS adopts default BFD parameters to establish BFD sessions on all the interfaces.

  4. (Optional) Run ipv6 bfd all-interfaces { min-rx-interval receive-interval | min-tx-interval transmit-interval | detect-multiplier multiplier-value | frr-binding } *

    IPv6 BFD parameters are configured for setting up BFD sessions.

    • min-rx-interval receive-interval: specifies the minimum interval at which BFD packets are received from the peer end.

    • min-tx-interval transmit-interval: specifies the minimum interval at which BFD packets are sent to the peer end.

    • detect-multiplier multiplier-value: specifies the local detection time multiplier, which determines the neighbor holdtime.

    • frr-binding: indicates that the status of the IPv6 BFD session is bound to IPv6 IS-IS Auto FRR.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 47049

Downloads: 58

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next