No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Binding IP FRR and BFD

(Optional) Binding IP FRR and BFD

Context

After the parameter frr-binding is set to bind the BFD status to the link status of an interface, link failures can be detected rapidly. This ensures that traffic is rapidly switched to the backup link if the primary link fails.

Pre-configuration Tasks

Before binding IP FRR and BFD, complete the following tasks:

Procedure

  • Bind IP FRR and BFD in an OSPF process.
    1. Run system-view

      The system view is displayed.

    2. Run ospf

      An OSPF process is started, and the OSPF view is displayed.

    3. Run bfd all-interfaces frr-binding

      IP FRR and BFD are bound in the OSPF process.

    4. Run commit

      The configuration is committed.

  • Bind IP FRR and BFD on a specified OSPF interface.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

    3. Run ospf bfd frr-binding

      IP FRR and BFD are bound on the interface.

      NOTE:

      The BFD configuration on an interface takes precedence over that in an OSPF process.

    4. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 45768

Downloads: 58

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next