No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Switch to Comply with External Route Selection Rules Defined in RFC 1583

Configuring a Switch to Comply with External Route Selection Rules Defined in RFC 1583

Context

All devices in an OSPF routing domain must be configured with the same route selection rules. At present, most OSPF routing domains adopt the route selection rules defined in RFC 2328.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF process view is displayed.

  3. (Optional) Run rfc1583 compatible

    The switch is configured to comply with the route selection rules defined in RFC 1583.

    By default, the routing rules defined in RFC 1583 are used.
    • If route selection rules defined in RFC 1583 are enabled, a device selects a route to the destination based on the route cost.
    • If route selection rules defined in RFC 1583 are disabled, a device selects a route to the destination based on the route type. In the case of the same route type, the device selects a route based on the route cost.
    NOTE:

    On a network, if not all switches use the route selection rules defined in RFC 1583, external loops may occur.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 46988

Downloads: 58

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next