No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IPv4 FRR

Configuring IPv4 FRR

Applicable Environment

If a link failure occurs after FRR is enabled, the fault detection module reports the failure to the upper-layer routing system. The FRR module immediately uses a backup link to forward packets, minimizing the impact of the link failure on services. IPv4 FRR applies to the services that are very sensitive to delay and packet loss on IPv4 networks.

IPv4 FRR implements route backup among routes of different routing protocols and may cause routing loops. Therefore, exercise caution when using IPv4 FRR.

With IP FRR, traffic is switched to a backup link if the primary link fails and switched back when the primary link recovers. If the inbound and outbound interfaces reside on different boards, packet loss may occur during the switchback. The packet loss duration varies with the service volume and CPU usage. To prevent the packet loss, perform any of the following operations:

  • Run the timer spf command in the IS-IS view.
  • Run the spf-schedule-interval command in the OSPF view.
  • Run the route-select delay command in the BGP view.

Pre-configuration Tasks

Before configuring IPv4 FRR, complete the following task:

  • Configuring link layer protocol parameters and assigning IPv4 addresses to interfaces to ensure that the link layer protocol of the interfaces is Up

  • Configuring IPv4 routes destined for the same destination address but discovered by different routing protocols

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ip frr

    IPv4 FRR is enabled.

    By default, IPv4 FRR is disabled.

    NOTE:

    When FRR is configured in both the system view and the routing protocol view, FRR configured in the routing protocol view is used for route backup.

  3. Run commit

    The configuration is committed.

Verifying the Configuration

After IPv4 FRR is configured, run the following command to check the configuration.

Run the display ip routing-table verbose command to check detailed information about the backup outbound interfaces and backup next hops of routes in the routing table.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 56779

Downloads: 62

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next