No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Static Default Routes

Static Default Routes

A default route has all 0s as its destination IP address. The default route can be automatically generated by a routing protocol or manually configured. The manually configured default route simplifies network configuration. If the destination address of a packet fails to match any entry in the routing table, the router selects the default route to forward the packet.

Figure 2-6 Networking diagram of static routes

In Figure 2-6, if no static default route is configured, you need to configure static routes destined for networks 3, 4, and 5 on RouterA, configure static routes destined for networks 1 and 5 on RouterB, and configure static routes destined for networks 1, 2, and 3 on RouterC. In this way, RouterA, RouterB, and RouterC can communicate with each other.

The next hop of the packets sent by RouterA to networks 3, 4, and 5 is RouterB. Therefore, a default route configured on RouterA can replace the three static routes destined for networks 3, 4, and 5 in the preceding example. Similarly, just one default route from RouterC to RouterB can replace the three static routes destined for networks 1, 2, and 3 in the preceding example.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 47204

Downloads: 58

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next