No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Extended Community Filter

Configuring an Extended Community Filter

Context

To filter routes based on extended community attributes, you can use an extended community filter.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Configure an extended community filter.

    • Run ip extcommunity-filter { basic-extcomm-filter-num | basic basic-extcomm-filter-name } [ index index-number ] { deny | permit } { rt { as-number:nn | 4as-number:nn | ipv4-address:nn } } &<1-16>

      Or run ip extcommunity-filter { advanced-extcomm-filter-num | advanced advanced-extcomm-filter-name } [ index index-number ] { deny | permit } regular-expression

      An RT extended community filter is configured.

    • Run ip extcommunity-list soo basic basic-extcomm-filter-name [ index index-number ] { permit | deny } { site-of-origin } &<1-16>

      Or run ip extcommunity-list soo advance advanced-extcomm-filter-name [ index index-number ] { permit | deny } regular-expression

      An SoO extended community filter is configured.

  3. Run commit

    The configuration is committed.

Verifying the Configuration

Run the display ip extcommunity-filter [ basic-extcomm-filter-num | advanced-extcomm-filter-num | extcomm-filter-name ] command to check information about the configured extended community filter.

Run the display ip extcommunity-list soo [ extcomm-filter-name ] command to check information about the configured SoO extended community attribute.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 50739

Downloads: 60

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next