No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring BFD for OSPF

Configuring BFD for OSPF

Applicable Environment

A link fault or a topology change causes devices to recalculate routes. Therefore, the convergence of routing protocols must be speed up to improve the network performance.

Link faults are inevitable. Therefore, a feasible solution is required to fast detect faults and notify routing protocols of the faults immediately. If BFD is associated with routing protocols, once a link fault occurs, BFD can speed up the convergence of routing protocols.

Pre-configuration Tasks

Before configuring BFD for OSPF, complete the following tasks:

Configuration Procedure

Figure 5-30 Flowchart of configuring BFD for OSPF
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 55236

Downloads: 62

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next