No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the BGP Network Convergence Speed Adjustment Configuration

Verifying the BGP Network Convergence Speed Adjustment Configuration

Procedure

  • Run the display bgp peer [ verbose ] command to check information about all BGP peers.
  • Run the display bgp group [ group-name ] command to check information about the specified BGP peer group.
  • Run the display bgp routing-table dampened command to check dampened BGP routes.
  • Run the display bgp routing-table dampening parameter command to check configured BGP route dampening parameters.
  • Run the following commands to check route flapping statistics:

    • display bgp routing-table flap-info [ regular-expression as-regular-expression ]
    • display bgp routing-table flap-info [ as-path-filter { as-path-filter-number | as-path-filter-name } | network-address [ { mask | mask-length } [ longer-match ] ] ]

  • Run the display bgp multicast routing-table dampened command to check dampened MBGP routes.
  • Run the display bgp multicast routing-table dampening parameter command to check MBGP route dampening parameters.
  • Run the following commands to check statistics about flapping MBGP routes:

    • display bgp multicast routing-table flap-info [ ip-address [ mask [ longer-match ] | mask-length [ longer-match ] ] | as-path-filter { as-path-filter-number | as-path-filter-name } ]
    • display bgp multicast routing-table flap-info regular-expression as-regular-expression

  • Run the display bgp slow-peer command to check information about slow BGP peers.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 45878

Downloads: 58

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next