No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MP-BGP

Configuring MP-BGP

Pre-configuration Tasks

Multiprotocol BGP (MP-BGP) enables BGP to support IPv4 unicast networks, IPv4 multicast networks, and IPv6 unicast networks.

Before configuring MP-BGP, complete the following task:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    BGP is started, the local AS number is specified, and the BGP view is displayed.

  3. Enter the corresponding address family view based on network type to configure BGP devices on networks.
    • Run ipv4-family unicast

      The BGP-IPv4 unicast address family view is displayed.

    • Run ipv4-family vpnv4

      The BGP-VPNv4 address family view is displayed.

    • Run ipv4-family vpn-instance vpn-instance-name

      The BGP-VPN instance IPv4 address family view is displayed.

    • Run ipv4-family multicast

      The BGP-IPv4 multicast address family view is displayed.

    • Run ipv6-family [ unicast ]

      The BGP-IPv6 unicast address family view is displayed.

    NOTE:

    Different extended BGP functions must be configured in their respective address family views, while common BGP functions are configured in the BGP view.

  4. Configure the following MBGP features supported by the Switch:

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 50708

Downloads: 60

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next