No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Improving RIPng Network Performance

Improving RIPng Network Performance

You can adjust and optimize the RIPng network performance by configuring RIPng functions in special network environments, such as configuring RIPng timers, setting the interval for sending packets, and setting the maximum number of packets to be sent.

Pre-configuration Tasks

Before improving RIPng network performance, complete the following task:

Configuration Procedure

You can perform the following configuration tasks (excluding the task of Verifying the RIPng Network Performance Optimization Configuration) in any sequence as required.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 45195

Downloads: 58

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next