No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Interval for Receiving LSAs

Setting the Interval for Receiving LSAs

Context

When a network is unstable, control the minimum interval for receiving the same LSA update. To prevent unnecessary LSA updates caused by network changes, by default, an intelligent timer is enabled. The interval for receiving LSAs is expressed in milliseconds. The maximum interval for updating LSAs is 1000 milliseconds (ms), the initial interval is 500 ms, and the Holdtime interval is 500 ms.

Do as follows on the switch that runs OSPFv3.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospfv3 [ process-id ]

    The OSPFv3 view is displayed.

  3. Run lsa-arrival-interval { interval | intelligent-timer max-interval start-interval hold-interval }

    The interval for receiving LSAs is set.

  4. (Optional) Run lsa-arrival-interval suppress-flapping suppress-interval

    The maximum OSPFv3 LSA suppression period is configured.

    If frequent OSPFv3 LSA flapping occurs, the larger value between lsa-arrival-interval suppress-flapping and lsa-arrival-interval is used to suppress LSA flapping.

    By default, if the device receives an LSA, it delays route calculation for 10s.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 46863

Downloads: 58

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next