No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Convergence Priority of OSPF Routes

Setting the Convergence Priority of OSPF Routes

Context

With the integration of network services, different services such as data, voice, and video run on the same network infrastructure, but them have different requirements on the network. For Video on Demand (VoD) services, the route convergence speed of the multicast source server is the most critical factor that affects multicast services. It is required that the routes to the multicast source converge rapidly when network faults occur. On the BGP or MPLS VPN bearer network where OSPF is used to implement the IP connectivity of the backbone network, end-to-end routes between PEs need to converge rapidly.

You can set the convergence priority of certain OSPF routes to a larger value so that these routes converge preferentially. This shortens the interruption of key services and improves the reliability of the entire network.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF view is displayed.

  3. Run prefix-priority { critical | high | medium } ip-prefix ip-prefix-name

    The convergence priority of certain OSPF routes is set.

    After the convergence priority of certain OSPF routes is set, OSPF can calculate and flood LSAs, and synchronize LSDBs according to the priority. This speeds up the route convergence. When an LSA meets multiple priorities, the highest priority takes effect. Before a convergence priority is set, OSPF calculates LSAs based on the routes carried in them, namely, in the sequence of intra-area routes, inter-area routes, and AS external routes. This command makes OSPF calculate the three types of routes separately according to the specified route calculation priorities. Convergence priorities include critical, high, medium, and low. During LSA flooding, LSAs are placed into the corresponding critical, high, medium, and low queues based on their priorities, which speeds up the processing of high-priority LSAs.

    NOTE:

    This command takes effect only on the public network.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 58668

Downloads: 63

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next