No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring OSPF Stub Areas

Configuring OSPF Stub Areas

Applicable Environment

Dividing an AS into different areas can reduce the number of LSAs transmitted on a network and enhance OSPF extensibility. For some non-backbone areas on the border of an AS, you can configure these areas as stub areas to further reduce the size of the routing tables and the number of transmitted LSAs.

Pre-configuration Tasks

Before configuring OSPF stub areas, complete the following tasks:

Configuration Procedure

Figure 5-28 Flowchart of configuring OSPF stub areas
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 55163

Downloads: 62

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next