No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling RIP on the Specified Network Segment

Enabling RIP on the Specified Network Segment

Context

After enabling RIP, you need to specify the network segment in which RIP runs. RIP runs only on the interfaces on the specified network segment. RIP does not receive, send, or forward routes on the interfaces that do not reside on the specified network segment.

Procedure

  • Enable RIP to send and receive routes on the specified network segment.
    1. Run the system-view command to enter the system view.
    2. Run the rip [ process-id ] command to enter the RIP view.
    3. (Optional) Run the undo verify-source command to disable source check for RIP packets.

      If the IP addresses on two ends of a P2P link belong to different network segments, the devices on the two ends cannot set up neighbor relationship unless source check is disabled.

    4. Run the network network-address command to enable RIP on the specified network segment.

      NOTE:
      • network-address specifies the address of a natural network segment.
      • An interface can be associated with only one RIP process.

    5. Run commit

      The configuration is committed.

  • Enable RIP to send and receive routes on all network segments connected to the specified interface.
    1. Run the system-view command to enter the system view.
    2. Run the interface interface-type interface-number command to enter the interface view.
    3. On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

      The mode switching function takes effect when the interface only has attribute configurations (for example, shutdown and description configurations). Alternatively, if configuration information supported by both Layer 2 and Layer 3 interfaces exists (for example, mode lacp and lacp system-id configurations), no configuration that is not supported after the working mode of the interface is switched can exist. If unsupported configurations exist on the interface, delete the configurations first and then run the undo portswitch command.

      NOTE:

      If many Ethernet interfaces need to be switched to Layer 3 mode, run the undo portswitch batch interface-type { interface-number1 [ to interface-number2 ] } &<1-10> command in the system view to switch these interfaces to Layer 3 mode in batches.

    4. Run the rip enable process-id command to enable RIP on all network segments connected to the interface.
    5. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 45716

Downloads: 58

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next