No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Specifying the RIP Version

(Optional) Specifying the RIP Version

Context

RIP versions include RIP-1 and RIP-2. The two versions have different functions. The RIP version must be set on the device running RIP. You only need to set the global RIP version unless you want to specify a different RIP version on an interface.

Procedure

  • Configure the global RIP version.
    1. Run the system-view command to enter the system view.
    2. Run the rip [ process-id ] command to enter the RIP view.
    3. Run the version { 1 | 2 } command to set the global RIP version.

      NOTE:

      By default, an interface sends only RIP-1 packets and receives both RIP-1 and RIP-2 packets.

    4. Run commit

      The configuration is committed.

  • Configure the RIP version for an interface.
    1. Run the system-view command to enter the system view.
    2. Run the interface interface-type interface-number command to enter the interface view.
    3. On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

      The mode switching function takes effect when the interface only has attribute configurations (for example, shutdown and description configurations). Alternatively, if configuration information supported by both Layer 2 and Layer 3 interfaces exists (for example, mode lacp and lacp system-id configurations), no configuration that is not supported after the working mode of the interface is switched can exist. If unsupported configurations exist on the interface, delete the configurations first and then run the undo portswitch command.

      NOTE:

      If many Ethernet interfaces need to be switched to Layer 3 mode, run the undo portswitch batch interface-type { interface-number1 [ to interface-number2 ] } &<1-10> command in the system view to switch these interfaces to Layer 3 mode in batches.

    4. Run the rip version { 1 | 2 [ broadcast | multicast ] } command specify the RIP version on the specified interface.

      NOTE:
      • By default, an interface sends only RIP-1 packets and receives both RIP-1 and RIP-2 packets.
      • If no RIP version number is configured in the interface view, the global RIP version is used. The RIP version set on an interface takes precedence over the global RIP version.

    5. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 57812

Downloads: 63

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next