No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
IP FRR

IP FRR

Definition

When a router detects a fault at the physical or data link layer, IP fast reroute (FRR) enables the router to report the fault to the upper-layer routing system, and to immediately use a backup link to forward packets. IP FRR is a method that implements fast route backup.

Purpose

On traditional IP networks, when a fault occurs at the lower layer of the forwarding link, the physical interface on the router becomes Down. After the router detects the fault, it informs the upper-layer routing system to recalculate routes and then update routing information. Usually, it takes the routing system several seconds to re-select an available route.

Second-level convergence is intolerable to services that are sensitive to delay and packet loss because it may lead to service interruption. For example, Voice over Internet Protocol (VoIP) services are only tolerant of millisecond-level interruption.

IP FRR resolves this by ensuring that the forwarding system rapidly detects a link fault and then uses a backup route to restore services as soon as possible.

IP FRR Classification and Implementation

IP FRR, which is designed for routes on IP networks, is classified into IP FRR on public networks and IP FRR on private networks.

  • IP FRR on public networks protects routers on public networks.

  • IP FRR on private networks protects Customer Edges (CEs).

IP FRR is implemented as follows:

  1. If the primary link is available, you can configure an IP FRR policy to provide the forwarding information of the backup route to the forwarding engine.

  2. If the forwarding engine detects a link fault, the engine uses the backup link to forward traffic before the routes on the control plane converge.

IP FRR Typical Applications

In the example shown in Figure 1-5, IP FRR is configured to improve network reliability. CE1 is dual-homed to PE1 and PE2 and has two outbound interfaces and two next hops configured. That is, link B functions as the backup of link A. When link A fails, traffic can be rapidly switched to link B.

Figure 1-5 IP FRR
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 55201

Downloads: 62

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next