No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IPv6 FRR

Configuring IPv6 FRR

Applicable Environment

After IPv6 FRR is configured, if a link fault is detected at a lower layer (physical layer or link layer), the fault is reported to the upper-layer routing system. Meanwhile, packets are forwarded using a backup link to minimize the impact of the link fault on services. IPv6 FRR is applicable to services that are very sensitive to the delay and packet loss on an IPv6 network.

IPv6 FRR enables routes generated by different routing protocols to back up each other, which may cause a loop. Therefore, exercise caution when configuring IPv6 FRR.

With IP FRR, traffic is switched to a backup link if the primary link fails and switched back when the primary link recovers. If the inbound and outbound interfaces reside on different boards, packet loss may occur during the switchback. The packet loss duration varies with the service volume and CPU usage. To prevent the packet loss, perform any of the following operations:

  • Run the timer spf command in the IS-IS view.
  • Run the spf-schedule-interval (OSPFv3) command in the OSPFv3 view.
  • Run the route-select delay command in the BGP view.

CE6810LI does not support IPv6 FRR.

Pre-configuration Tasks

Before configuring IPv6 FRR, complete the following tasks:

  • Configuring link layer protocol parameters and assigning IPv6 addresses to interfaces to ensure that the link layer protocol on the interfaces is Up

  • Configuring IPv6 routes destined for the same destination address but discovered by different routing protocols

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ipv6 frr

    IPv6 FRR is enabled.

    By default, IPv6 FRR is disabled.

    NOTE:

    When IPv6 FRR is configured in both the system view and the routing protocol view, the IPv6 FRR configuration in the routing protocol view takes effect.

  3. Run commit

    The configuration is committed.

Verifying the Configuration

Run the display ipv6 routing-table verbose command to check detailed information about backup outbound interfaces and backup next hops of routes in the routing table.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 45287

Downloads: 58

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next