No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring BFD for OSPFv3

Configuring BFD for OSPFv3

Usage Scenario

To speed up OSPFv3 convergence when the link status changes, you can configure BFD for OSPFv3 links.

BFD detects links much faster than keep-alive protocols do. If OSPFv3 is bound to BFD sessions, BFD can notify OSPFv3 of link failures immediately, and then OSPFv3 perform route calculation and convergence in the new network topology.

Pre-configuration Tasks

Before configuring BFD for OSPFv3, complete the following tasks:

  • Configure basic OSPFv3 functions.

Configuration Procedure

Figure 6-11 Flowchart for configuring BFD for OSPFv3
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 57486

Downloads: 62

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next