No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring BFD for a Specified Interface

(Optional) Configuring BFD for a Specified Interface

Context

To configure BFD only on a specified interface, or enable an interface to detect link failures faster after BFD for OSPFv3 is enabled globally, perform the following steps on the interface:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run ospfv3 bfd enable

    BFD is enabled on the interface to establish a BFD session.

    When BFD is configured globally and the neighbor status is Full, OSPFv3 establishes BFD sessions on all the neighbors in the process using default BFD parameters.

    You can run the ospfv3 bfd { min-transmit-interval min-transmit-value | min-receive-interval min-receive-value | detect-multiplier multiplier-value | frr-binding } * [ instance instance-id ] command to set parameters for BFD sessions.

    NOTE:
    • The BFD configured on an interface takes precedence over that configured in a process. Specifically, if BFD is enabled on an interface, BFD parameters on the interface are used to establish BFD sessions.

    • If the parameters of a BFD session are set but the ospfv3 bfd enable command is not run, BFD cannot be enabled.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 45779

Downloads: 58

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next