No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Basic BGP Function Configuration

Verifying the Basic BGP Function Configuration

Procedure

  • Run the display bgp peer [ verbose ] command to check information about all BGP peers.
  • Run the display bgp peer ipv4-address { log-info | verbose } command to check information about the specified BGP peer.
  • Run the display bgp routing-table [ ipv4-address [ { mask | mask-length } [ longer-prefixes ] ] ] command to check BGP routing information.
  • Run the display bgp group [ group-name ] command to check information about the specified BGP peer group.
  • Run the display bgp multicast peer [ [ peer-address ] verbose | peer-address { statistics | verbose } ] command to check information about the specified MBGP peer.
  • Run the display bgp multicast group [ group-name ] command to check information about an MBGP peer group.
  • Run the display bgp multicast network command to check the routing information that MBGP advertises.
  • Run the display bgp multicast routing-table [ ip-address [ mask-length [ longer-prefixes ] | mask [ longer-prefixes ] ] ] command to check the MBGP routing information of a specified network in the MBGP routing table.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 46847

Downloads: 58

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next