No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Static BFD for IPv4 Static Routes

(Optional) Configuring Static BFD for IPv4 Static Routes

Pre-configuration Tasks

Before configuring static BFD for IPv4 static routes, complete the following tasks:

  • Configure link layer parameters and IP addresses for interfaces to ensure network-layer communication between neighbor nodes.

  • Configure BFD sessions.

    For details, see "BFD Configuration" in the CloudEngine 8800, 7800, 6800, and 5800 Series Switches- Configuration Guide - Reliability.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run either of the following commands as required:
    • Run ip route-static ip-address { mask | mask-length } { nexthop-address | interface-type interface-number [ nexthop-address ] | vpn-instance vpn-instance-name nexthop-address } track bfd-session cfg-name [ description text ]

      A BFD session is bound to an IPv4 static route on the public network.

    • Run ip route-static vpn-instance vpn-source-name destination-address { mask | mask-length } { nexthop-address | interface-type interface-number [ nexthop-address ] | vpn-instance vpn-instance-name nexthop-address } track bfd-session cfg-name [ description text ]

      A BFD session is bound to an IPv4 static route on the VPN network.

    NOTE:

    Before binding a static route to a BFD session, ensure that the BFD session and the static route reside on the same link.

  3. Run commit

    The configuration is committed.

Verifying the Configuration

Run the following commands to verify the configuration.

  • Run the display bfd session all [ verbose ] command to check information about the BFD session.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 57596

Downloads: 63

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next