No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the OSPFv3 Routing Information Control Configuration

Verifying the OSPFv3 Routing Information Control Configuration

Prerequisites

The configurations for Controlling OSPFv3 Routing Information are complete.

Procedure

  • Run the display ospfv3 [ process-id ] command to check the summary information about the OSPFv3 process.
  • Run the display ospfv3 [ process-id ] interface [ [ area area-id ] [ interface-type interface-number ] | no-peer ] command to check the OSPFv3 interface information.
  • Run the following commands to check the LSDB information about OSPFv3:

    • display ospfv3 [ process-id ] lsdb [ area area-id ] [ originate-router advertising-router-id | self-originate ] [ { external | grace | inter-prefix | inter-router | intra-prefix | link | network | router | router-information | nssa } [ link-state-id ] ] [ resolve-hostname | age { min-value min-age-value | max-value max-age-value } * ]

    • display ospfv3 [ process-id ] lsdb [ area area-id ] hostname hostname [ { external | grace | inter-prefix | inter-router | intra-prefix | link | network | router | router-information | nssa } [ link-state-id ] ] [ age { min-value min-age-value | max-value max-age-value }* ]

  • Run the following commands to check the OSPFv3 routing table:

    • display ospfv3 [ process-id ] routing [ [ ipv6-address prefix-length ] | ase-routes | inter-routes | intra-routes | nssa-routes ] [ verbose ] [ age { min-value min-age-value | max-value max-age-value } * ]

    • display ospfv3 [ process-id ] routing statistics

  • Run the display default-parameter ospfv3 command to check the default OSPFv3 configuration.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 45766

Downloads: 58

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next